Table of Contents
Advertisement
6. OPERATION
6.1 Sharpening end mills (rear corner)
Apices template double rod is fixed in the machine. The support of the cutting
tool is at the top of the clamp. The stop of the clamp is fixed to the sliding
table. Buffer end gag is 3-5mm lower than the centerline of the shaft. The
right hand rotates the shaft tooth per tooth, and the left hand moves the
worktable in longitudinal and sharpens the cutting tool.
Make sure that the cutting tool does not slip out of the clamp when the
worktable is moved to the sides.
C/Casanovas 1, 08782, St. Joan Samora - Barcelona (Spain) - Phone +34 932 935 178 - info@elite.cat
17
!
Advertisement
Table of Contents
