Table of Contents
Advertisement
c. PIP/POP Feature – This monitor will allow you to view two locations simultaneously, one being
the main channel, the other camera being viewed in picture in picture. To utilize this feature,
proceed as follows:
i. Press the Mode/Alrs button, the monitor will automatically switch to PIP feature, pressing
this button a second time will switch to POP feature.
ii. To change the MAIN channel screen press the Right/Left arrow keys on the remote
control. To change the PIP/POP channel screen, press the Right/Left arrow keys on the
monitor. Press the Down arrow key on the remote control to reverse screens (Main
screen switched to PIP/POP screen and PIP/POP screen is now Main screen).
Screen shots of PIP/POP Mode
C1
NOTE:
6. Zoom – In Full Screen mode, press this button to Zoom in selected area of the picture. Use the
cursor buttons to move the highlighted area to Zoom area. Not available in Quad, PIP and POP
mode.
7. VCR Button – This button will change the display from the camera inputs to the VCR Audio/Video
playback and recording signal. The amber LED light located over this button will be ON when the
VCR mode selection has been chosen. Press the button again to return to Actual.
8. Sequential Display Select Button – This button will place the unit into sequential display mode.
The amber LED light located over this button will be OFF when in Quad Mode. The amber LED
light will be ON in sequential display mode. In sequential display mode, the monitor will
automatically rotate between the different cameras.
9. Talk Button – In Full screen mode, by pressing and holding this button the user has the ability to
talk to a specific camera location. This button must be pressed the entire time, while talking. To
listen to the camera location release the talk button. Note: This feature is only available with the
wired cameras, which have two-way audio feature.
10. Channel 1 – In FULL screen mode, if picture is Camera 1, press this button to 'Freeze' this picture
image – the 'F' letter will appear on the top right hand corner. The LED light located over this
button will be ON. Pressing the button a second time will Exit from the 'Freeze' mode.
11. Channel 2 – In FULL screen mode, if picture is Camera 2, press this button to 'Freeze' this picture
image – the 'F' letter will appear on the top right hand corner. The LED light located over this
button will be ON. Pressing the button a second time will Exit from the 'Freeze' mode.
PIP
C2
If the alarm feature has been used by connecting external alarm devices (refer to
Appendix C) to the monitor, the buttons will be disabled until the Mode/Alrs
button has been pressed. In the event of more than one alarm occurs, the
monitor will automatically switch to Quad screen mode to display the multiple
alarm locations.
C1
C2
POP
-7-
Advertisement
Table of Contents
