Before First Use - Progress PI1545X User Manual

How to set the water softener
level
The appliance must be in programme
selection mode.
1. Make sure that the programme marker
on the knob is aligned with the indicator
on/off .
2. To enter the user mode, press and hold
Delay. At the same time turn the knob
counterclockwise until the symbol of the
first programme is aligned with the
on/off indicator. Release Delay when
the indicators Start and on/off start to
flash.

BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the baskets.
When you start a programme, the
appliance can take up to 5 minutes to
recharge the resin in the water softener. It
seems that the appliance is not working.
The washing phase starts only after this
procedure is completed. The procedure will
be repeated periodically.
The salt container
CAUTION! Only use salt
specifically designed for
dishwashers.
The salt is used to recharge the resin in the
water softener and to assure good washing
results in the daily use.
3. Press Delay.
• The indicator
• The indicators Start and on/off
continues to flash.
• The intermittent flashing of
refers to the current set level, e.g. 5
flashes + pause + 5 flashes = level 5.
4. Press Delay again and again to change
the setting. Each time you press Delay
the level number increases. After level
10 you will start again from level 1.
5. Turn knob to on/off position to confirm
the setting.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt container
(Only for the first time).
3. Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap of the salt container
clockwise to close the salt container.
Progress 9
starts to flash.