4. Troubleshooting
4-1. Self test program and error check list
- Press the Start key for three seconds (buzzer ring one time), and press the POWER key to enter Self test program started
- Self test program flow
LED check
KEY check
- If you want to activate a self test program while operating the dishwasher, the door must be closed (The Door switches are ON.)
- Service Inspection Mode is described in the following table.
Mode
Related parts
< Lighting procedure >
LED check
NO.1
1) [1] is displayed and waits key input to Remain indicator.
NO.2
KEY check
SENSOR checkach
All manuals and user guides at all-guides.com
SENSOR check
LOADcheck
- Progress to NO 2 if is completed all by upside procedure.
- Progress by 2) if all key are pressed down more than 1.
- Whenever you press key, you can hear the sounds from buzzer.
1) [dr] is displayed and wait state change of door switch.
5) [St] is displayed and waits state change of salt switch
A/D check
end
Note
- If there is state change, buzzer rings 1 times and progresses by 2).
- You can progress next operation by pushing Plus Select button.
(Skip function is all possible from 1)~6).)
- If there is state change, buzzer rings 1 times and progresses by 5).
- If there is state change, buzzer rings 1 times and progresses by 5).
- If there is state change, buzzer rings 1 times and progresses by 6).
Troubleshooting