Returning To A Pre-Marked Position - Canon Optura 100 Instruction Manual

Returning to a Pre-Marked Position

E
Use the wireless controller to mark a point on a tape that you want to return to
following playback.
+
TAPE CAMERA
1. Press the ZERO SET MEMORY button on the wireless controller
during playback at a point you want to return to later.
• The time code is replaced by a tape counter that is set to zero with the Â
indication.
• Press the ZERO SET MEMORY button once more to cancel the zero set
memory.
2. When you have finished playback, fast forward or rewind the tape.
The tape stops automatically when it reaches the zero set position.
• RTN1 or `RTN appears in the display.
• The tape counter with  indication disappears from the display and the time
code reappears.
Notes:
• The zero set memory may not function correctly where there is a break between
recordings on the tape.
• You can also use zero set memory to mark a position on a tape in TAPE
CAMERA mode. When you then play back the tape, pressing rewind will take
you back to the pre-marked position.
• If you remove the tape while the zero set memory is set, the memory is
canceled and the tape counter reverts to time code.
• The camcorder remembers your setting even if you turn it off and back on again
or move the program selector.
84
,
PLAY
+
TAPE
(VCR)
ZERO SET
SEARCH
MEMORY
SELECT
AUDIO
FF
REW PLAY
DUB.
AV
– / STOP + /
INSERT
× 2
PAUSE SLOW
REMOTE SET