TURNTABLE SETUP • Carefully unpack the turntable. Always keeping it upright. • Place the turntable on a level surface. • Connect the power supply to the rear of 331/3 RPM the turntable (1). • Connect the phono output (2) to INPUT 1 on the io amplifier (PHONO).
To change between inputs, press the small black button located next to the row of input For grounding third-party tonearms. NOT REQUIRED FOR USE WITH REGA SYSTEM ONE digits to cycle through 1-3. The selected input is highlighted in red. Input selection can also be...
We recommend that any servicing is carried out via a registered Rega dealer, you can find your nearest Rega dealer on www.rega. co.uk/dealers. MOVE ON TO...
LIFETIME WARRANTY SAFETY INSTRUCTIONS All Rega products are covered by a lifetime warranty against manufacture defects. This warranty does not Recommended ambient operating temperature 5 to 35°C. Allow adequate air circulation around the cover wear and tear. Any unauthorised modifications or failure to follow the Rega recommended guidelines whole of the io especially its sides as this is where most of the heat is dispersed.
Page 7
80W per canale 80W por canal High frequency unit Unité haute fréquence Hochfrequenzeinheit Tweeter Unidad de alta frecuencia Rega ZRR Rega ZRR Rega ZRR Rega ZRR Rega ZRR Mid / bass driver (doped cone) Haut-parleur moyen/grave (cône rugueux) Mitteltieftöner (dotierter Konus)
Page 8
Rega Research Ltd. 6 Coopers Way Temple Farm Industrial Estate Southend-on-Sea, Essex SS2 5TE REGA SYSTEM ONE User Manual v1 MADE IN ENGLAND SINCE 1973...