Frigidaire FGF316ASA Installation Instructions Manual page 10

30" GAS RANGE INSTALLATION INSTRUCTIONS
1c. Convert the Pressure Regulator - Non-Self-
Cleaning Standing Pilot Models
a. Remove the cap from the pressure regulator.
b. Remove the plunger from the cap.
c. Turn the plunger with the enlarged end down for LP/
Propane use. Turn the plunger with the small end down for
Natural gas use. (See illustration below.)
d. Replace the plunger inside the cap.
e. Replace the cap.
f. Remove the thermostat knob to access the selector key.
Check the selector key on the thermostat to be certain the
pointer is turned to select the proper fuel being used
(Natural or LP/Propane). Replace the thermostat knob.
2. Convert Surface Burner Valves -All Models
a. Lift and lock cooktop to gain access to the surface burner
spuds. Surface burner spuds for models with venturi
burners are located in the front of the burner box. For
models with dual or snap-in burners, the spuds are in the
bottom of the burner box.
b. Using 1/2" wrench, adjust surface burner spud as follows.
For Natural to LP/Propane conversion tighten spud down
clockwise until snug (approximately 2-1/2 turns). This
restricts the flow of gas through the spuds to only that
allowed by the hollow LP/Propane metering pin. Do not
over tighten.
For LP/Propane to Natural conversion, loosen spuds
counter-clockwise (approximately 2-1/2 turns). This
increases the flow of gas around the metering pin.
3. Convert Oven Burner Spud
(For Models with Electric Ignition or Standing Pilot)
a. Remove oven bottom and oven burner baffle located on
top of burner. To remove oven bottom, remove oven hold
down screws at rear of oven bottom. Pull up at rear,
disengage front to oven bottom from oven front-frame,
and pull the oven bottom straight out of the oven. Remove
nut attaching burner baffle to oven burner.
b. Using 1/2" wrench, adjust oven burner spud as follows.
For Natural to LP/Propane conversion tighten spud down
clockwise until snug (approximately 2-1/2 turns). This
restricts the flow of gas through the spuds to only that
allowed by the hollow LP/Propane metering pin. Do not
over tighten.
For LP/Propane to Natural conversion, loosen spuds
counter-clockwise (approximately 2-1/2 turns). This
increases the flow of gas around the metering pin.
4. Convert Broil Burner Spud (if equipped)
a. Using 1/2" wrench, adjust broil burner spud as follows. For
Natural to LP/Propane conversion tighten spud down
clockwise until snug (approximately 2-1/2 turns). This
restricts the flow of gas through the spuds to only that
allowed by the hollow LP/Propane metering pin. Do not
over tighten.
For LP/Propane to Natural conversion, loosen spuds
counter-clockwise (approximately 2-1/2 turns). This
increases the flow of gas around the metering pin.
After conversion is complete, follow normal instructions
on page 3 for installation and burner operation/
adjustments. For models with linear flow valves, the low
"simmer" setting must be adjusted after conversion.
10