Trim Installation - Martin SF42 Series Installation, Operation And Maintenance Manual

T I
RIM NSTALLATION
INSTALLATION OF NON-COMBUSTIBLE FACING MATERIALS TO THE FRONT FACE OF THE FIREPL INSTALLATION OF NON-COMBUSTIBLE FACING MATERIALS TO THE FRONT FACE OF THE FIREPLACE
COMBUSTIBLE FRAMING
MEMBERS FACING MATERIAL
TO TOP OF SPACERS.
F 29
IGURE
INSTALLATION OF COMBUSTIBLE DECORATIVE TRIM AND THE FIREPLACE SURROUND INSTALLATION OF COMBUSTIBLE DECORATIVE TRIM AND THE FIREPLACE SURROUND
COMBUSTIBLE FRAMING MEMBERS
FACING MATERIAL TO TOP OF SPACERS.
F 30
IGURE
USE ONLY NON-COMBUSTIBLE
MATERIALS BELOW TOP
OF SPACERS.
1" AIR SPACE TO SIDES
AND REAR OF FIREBOX
IT IS RECOMMENDED THAT YOU
INSULATE OUTER AND INNER WALLS
OF CHASE. ALWAYS MAINTAIN THE OF CHASE. ALWAYS MAINTAIN THE
PROPER CLEARANCE.
F 31
IGURE
COMBUSTIBLE SURROUND COMBUSTIBLE SURROUND
MATERIALS MAY BE PLACED MATERIALS MAY BE PLACED
WITHIN SHADED AREAS. WITHIN SHADED AREAS.
(NOTE: COMBUSTIBLE (NOTE: COMBUSTIBLE
MATERIALS MUST NOT MATERIALS MUST NOT
OVERLAP BLACK PAINTED OVERLAP BLACK PAINTED
SURFACE.)
NON-COMBUSTIBLE
FACING MATERIAL
FIREPLACE FACE
OUTSIDE AIR INLET
SAFETY STRIP
NOTE:
WHEN AN APPROVED ANSI Z21.11.2 UNVENTED ROOM HEATER IS INSTALLED WHEN AN APPROVED ANSI Z21.11.2 UNVENTED ROOM HEATER IS INSTALLED
IN THIS FIREPLACE, AN H2853 CANOPY MUST ALSO BE INSTALLED.
OUTLINE OF OUTLINE OF
FIREPLACE FIREPLACE
FIREBRICK FIREBRICK
4"
(REF.)
USE ONLY NON-COMBUSTIBLE
MATERIALS BELOW TOP OF SPACERS.
STEEL LINTEL
(OPTIONAL)
CAUTION:
DO NOT COVER
OR RESTRICT SIDE VENT
AREAS WITH SURROUND
OR TRIM MATERIALS.
12" MAXIMUM
COMBUSTIBLE MANTEL
18" MINIMUM FROM FIREPLACE OPENING
TO BOTTTOM OF COMBUSTIBLE MANTEL,
(MANUFACTURER RECOMMENDATION).
SEE NOTE BELOW REGARDING H2853 CANOPY. SEE NOTE BELOW REGARDING H2853 CANOPY.
1/4"
SCREENED OPENING SCREENED OPENING
OF FIREPLACE
WARNING:
THE SPACE BETWEEN THE
FACE OF THE FIREPLACE
AND THE NON-COMBUSTIBLE
FACING MATERIAL MUST BE
SEALED. FAILURE TO
PROPERLY SEAL THIS CRACK
CAN CAUSE A POSSIBLE FIRE
HAZARD AND WILL VOID THE
WARRANTY.
TOP EDGE OF FIREPLACE
TOP EDGE OF FIREPLACE OPENING
HEARTH EXTENSION
FRAMING FRAMING
EXTEND LINE FROM OPPOSITE REAR OF EXTEND LINE FROM OPPOSITE REAR OF
FIREBOX THRU A POINT 4" IN FRONT OF FIREBOX THRU A POINT 4" IN FRONT OF
FIREPLACE FACE, AND 1" OUTSIDE OF FIREPLACE FACE, AND 1" OUTSIDE OF
SCREENED OPENING. SCREENED OPENING.
FINISHED WALL FINISHED WALL
53D9022. Rev 1 03/03
27