Level The Range; Replace Oven Door(S) - Cafe C2Y486 Installation Instructions Manual

10

LEVEL THE RANGE

WARNING
The range must be level and be
supported by the legs—not the wheels. The range could
move if the wheels make contact with the floor. Be sure
all legs make contact with the floor in any installation.
opening of the range.
Measure the distance from the floor to the top of the
countertop in the left and right rear corners.
Adjust the height of the range to countertop height
or higher.
IMPORTANT: This range should always be installed
at countertop height or higher. DO NOT INSTALL THE
RANGE LOWER THAN ADJACENT COUNTERTOP
regardless of countertop height.
FRONT LEG ADJUSTMENT
front of the range near the right leg. Locate and
the slot.
Be careful not to damage cylinder.
Thumb Screw
stabilize the range. Turn counterclockwise to retract
the legs and allow the range to rest on its rollers.
future use.
14
Installation
10
REAR LEG ADJUSTMENT
WARNING
rod holes.
Remove two screws from rear vent trim. Slide vent
Remove the 2 spill plugs to locate the rear leg
wrench to adjust the left or right rear legs.
or wrench to adjust the left or right rear legs.
Replace the 2 spill plugs and then replace the rear
vent trim using the original screws.
11
Skip this step if oven doors are in place.
IMPORTANT: Do not lift the door by the handle.
To replace the oven doors:
Firmly grasp the door at the top sides. This is critical.
vertical position.
Slide leg
cylinder up.
the hinge locks back in toward the front frame.
CAUTION
doors. If the hinge latch
the hinge may snap back
and separate. If the hinge
pressure (possibly with
your foot) to press it back
together and then engage
the hinge latch.
LEVEL THE RANGE (cont.)
To reduce the risk of fire or electric
Spill Plugs

REPLACE OVEN DOOR(S)

Take care when replacing the oven
Rear Leg
Rods
31-2000815 Rev. 0