Cafe C2Y366 Installation Instructions Manual
  1. Manuals
  2. Brands
  3. Cafe Manuals
  4. Ranges
  5. C2Y366
  6. Installation instructions manual

Cafe C2Y366 Installation Instructions Manual

Dual fuel professional ranges
Hide thumbs Also See for C2Y366:
Table of Contents

Advertisement

Quick Links

Download this manual
36" and 48" Dual Fuel Professional Ranges
C2Y366, C2Y486
Contents
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Product Dimensions and Clearances . . . . . . . . . . . . . . . .4
High Altitude Kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Materials Provided . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Materials Required (not provided) . . . . . . . . . . . . . . . . . .7
Tools Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Remove Packaging . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Move the Range Indoors . . . . . . . . . . . . . . . . . . . . . . . . 9
Install Anti-Tip Device . . . . . . . . . . . . . . . . . . . . . . . . . 10
Gas Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Electrical Connections . . . . . . . . . . . . . . . . . . . . . . . . . 12
4-Wire Power Cord Installation . . . . . . . . . . . . . . . . . . 12
3-Wire Power Cord Installation . . . . . . . . . . . . . . . . . . 13
Roll Range into Position . . . . . . . . . . . . . . . . . . . . . . . . 13
Questions? Visit cafeappliances.com.
Installation Instructions
English • Français • Español
TM
Level the Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Replace Oven Door(s) . . . . . . . . . . . . . . . . . . . . . . . . . 14
Check Burners . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Check Surface Burners . . . . . . . . . . . . . . . . . . . . . . . . 15
Finalize Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
When All Hookups Are Completed . . . . . . . . . . . . . . . 15
Toekick . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Tools and Materials Required . . . . . . . . . . . . . . . . . . . 17
Install 12" Backsplash . . . . . . . . . . . . . . . . . . . . . . . . . 17
Tools and Materials Required . . . . . . . . . . . . . . . . . . . 18
Install the Wall Support Panels . . . . . . . . . . . . . . . . . . 19
Install Cover Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
31-2000815 Rev. 0 11-20 GEA

Advertisement

Table of Contents
loading

Related Manuals for Cafe C2Y366

Summary of Contents for Cafe C2Y366

  • Page 1: Table Of Contents

    Installation Instructions 36” and 48” Dual Fuel Professional Ranges C2Y366, C2Y486 Contents Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Level the Range .

  • Page 2: Safety Information

    Safety Information Have a question or need assistance with your appliance? Try the Café website 24 hours a day, any day of the year! You can also shop for more great Café products and take advantage of all our on-line support services designed for your convenience.
  • Page 3 Safety Information BEFORE YOU BEGIN IF SOLD OUTSIDE THE U.S. AND CANADA Read these instructions completely and carefully. WARNING IMPORTANT If you wish to use this product with ■ — Save these instructions Liquefied Petroleum (LP) gas containing greater than for local inspector’s use .

  • Page 4: Design Information

    Design Information PRODUCT DIMENSIONS AND CLEARANCES 48” Range Models 1” Countertop Universal Utility Locations to Cooking 47-7/8” Surface Width 8” 29 3/8” Depth to Front of Bullnose 16” 14” Gas/ 6-1/2” 35-1/4” to 36-3/4” Electric Electric Height to trim . 2” 3-1/4” Trim to be flush to 4-3/4”...
  • Page 5 Design Information PRODUCT DIMENSIONS AND CLEARANCES 36” Range Models Universal Utility Locations 1” Countertop 35-7/8” to Cooking Width Surface 4-5/8” 29 3/8” Depth to Front of Bullnose 11-3/8” 13-3/8” 35-1/4” to 36-3/4” Height to trim . Gas/ 6-1/2” Electric Trim to be flush Electric or higher than 2”...
  • Page 6 Design Information PRODUCT DIMENSIONS AND CLEARANCES 48” and 36” Range Models 29-3/8” To Front Edge 10-1/2” 13/16” 12” (36” models only) 30-36” Optional Backsplash Accessories 7” Control Panel Height 1” 35-1/4” 36-3/4” 28-1/2” To Front of Door 31-1/8” To Front of Handle 12”...

  • Page 7: Installation Information

    Installation Information INSTALLATION AT HIGH ALTITUDE TOOLS REQUIRED Over 6000ft, product configured for natural gas or propane requires installation of kit (WB28X39728 for natural gas and WB28X39729 for propane gas) . Follow the instructions included with the kit . Drill and Appropriate Bits Saber Saw MATERIALS PROVIDED Adjustable Wrench Measuring Tape 1/2” Pipe...

  • Page 8: Installation

    Installation REMOVE PACKAGING ■ O pen oven door(s) and remove packaging. Remove CAUTION Stand clear . The ends of the cut metal shelf holding broiler pan, tape, literature package, shelf banding may snap toward you . lubricant and probe . CAUTION ■ C ut the metal banding. Lift the carton straight up. Doors and passageways leading to the ■ L ocate the two runner strips from the top of the installation location require at least 32”...

  • Page 9: Move The Range Indoors

    Installation MOVE THE RANGE INDOORS 1 . Tilt the range forward on the skid . 4 . Attach the hand-truck straps around the unit . IMPORTANT: Place the hand-truck straps below the oven door handles. To avoid damaging the side panels, place a pad between the hand-truck and the range . 5 .

  • Page 10: Install Anti-Tip Device

    Installation INSTALL ANTI-TIP DEVICE WARNING Tip-Over Hazard • A child or adult can tip the range and be killed. • Install the anti-tip bracket to the wall or floor. • Engage the range to the anti-tip bracket by sliding the range back such that the foot is engaged.

  • Page 11: Converting To Propane (Lp) Gas Or Converting Back To Natural Gas From Propane (Lp)

    Installation CONVERTING TO PROPANE (LP) GAS SUPPLY (cont.) GAS OR CONVERTING BACK Shut off the main gas supply valve before TO NATURAL GAS FROM disconnecting the old range and leave it off until the new hook-up has been completed. Don’t PROPANE (LP) forget to relight the pilot on other gas appliances This range leaves the factory set for use with natural...

  • Page 12: Electrical Connections

    Installation ELECTRICAL CONNECTIONS ELECTRICAL CONNECTIONS (Cont.) A range cord rated at 40 amps with 125/250 minimum WARNING This appliance must be properly volt range is required . A 50 amp range cord is not grounded . recommended but if used, it should be marked for use with nominal 1 ⁄ ” diameter connection openings . WARNING All new constructions, mobile Care should be taken to center the cable and strain homes, recreational vehicles and installations where relief within the knockout hole to keep the edge from...

  • Page 13: 3-Wire Power Cord Installation

    Installation 4-WIRE POWER CORD 3-WIRE POWER CORD INSTALLATION (Cont.) INSTALLATION (Cont.) ■ R emove the 3 lower terminal screws from the ■ I nsert the 3 terminal screws (removed earlier) through each power cord terminal ring and into the terminal block . Insert the 3 terminal screws through lower terminals of the terminal block .

  • Page 14: Level The Range

    Installation LEVEL THE RANGE (cont.) LEVEL THE RANGE REAR LEG ADJUSTMENT WARNING The range must be level and be WARNING To reduce the risk of fire or electric supported by the legs—not the wheels . The range could shock, always replace the spill plugs in the leveling move if the wheels make contact with the floor . Be sure rod holes .

  • Page 15: Check Burners

    Installation FINALIZE INSTALLATION CHECK BURNERS Place the burner grates over the burners . The grates WARNING should be seated and should not rock . Fire or Explosion Hazard: Do not operate the burner without all burner parts in place . The griddle is secured with screws . It is designed to be stationary and should not be removed .

  • Page 16: Accessory Installation

    Accessory Installation TOEKICK (included) ■ I nstall the toekick after the range has been leveled. ■ S ecure the top and bottom sections by tightening the 2 screws on each end . ■ M easure the distance between the floor and the bottom of range . ■ P ush toekick against range leg until clip snaps to legs. ■ L oosen the two screws on each end. Adjust the NOTE: Be sure the toekick snaps securely to the leg . toekick height by sliding the upper and lower pieces apart to 1/8” less than the measured height.

  • Page 17: Ux12Bs36Pss, Ux12Bs48Pss Accessory Installation

    UX12BS36PSS, UX12BS48PSS Accessory Installation OPTIONAL ACCESSORIES—12” HIGH BACKSPLASH INSTALL 12” BACKSPLASH This kit provides for the installation of a 12” high backsplash for 36” Professional Ranges and Rangetops . WARNING This backsplash must be securely fastened to the wall . Failure to do so could result in TOOLS AND MATERIALS REQUIRED damage or personal injury .

  • Page 18: Uxadbs36Pss, Uxadbs48Pss Accessory Installation

    UXADBS36PSS, UXADBS48PSS Accessory Installation ACCESSORIES—30” TO 36” ADJUSTABLE BACKSPLASH (not included) INSTALL THE WALL SUPPORT PANELS ■ T his backsplash adjusts to fit the space between the top of the range and the bottom of the hood, WARNING from 30” Min. to 36” Max. height. The wall support panels must be securely fastened to the wall . Failure to do so could ■ M aximum shelf load-bearing weight is 40 lbs. result in damage or personal injury .

  • Page 19: Install The Wall Support Panels

    UXADBS36PSS, UXADBS48PSS Accessory Installation ACCESSORIES—30” TO 36” ADJUSTABLE BACKSPLASH (not included) (Cont.) INSTALL COVER PANELS INSTALL COVER PANELS (cont.) See alternate method if side access is blocked . ALTERNATE METHOD: When side access is blocked ■ H old the bottom cover over the bottom support ■ I nstall bottom cover over the bottom support while while driving one screw (provided) into each side .
  • Page 20 NOTE: While performing installations described in this book, safety glasses or goggles should be worn . NOTE: Product improvement is a continuing endeavor at GE Appliances. Therefore, materials, appearance and specifications are subject to change without notice . Printed in Mexico 31-2000815 Rev. 0...

This manual is also suitable for:

C2y486

Table of Contents