Table of Contents
Advertisement
Removing the existing receiver unit
A
A
ISO-DIN Installation
4
3
5
6
Control panel
Connection diagram
A
A
From antenna
B
B
To the wiring of the vehicle colors of leads.
• BLACK:
This lead is for the ground connection.
• ORANGE:
This lead is for the phone line connection.
• PINK:
This lead is for the dimmer line connection.
• RED:
This lead is for connection to the power supply terminal when the ignition
switch is set to ACC.
• YELLOW:
This lead is for connection to the battery (back-up) terminal from which
power is always supplied.
• BLUE:
This lead is for the power antenna connection.
• BLUE/WHITE: This lead is for the remote amplifier on connection.
C
C
Speaker Connections
REAR
FRONT
R
If there is already an installation sleeve for the receiver unit
in the dashboard, it must be removed.
1 Remove the rear support from the unit.
2 Remove the control panel and trim ring from the unit.
3 Insert the lever A into the hole on one side of the unit.
Perform the same operation on the other side and pull
the unit out from the mounting sleeve.
1 Slide the unit into the ISO-DIN frame.
2 Fit screws removed from the old unit.
3 Slide the unit and frame into the dash opening.
4 Install the dash panel or adapter plate.
1
5 Install the trim ring to the unit.
6 Install the control panel to the unit.
2
REAR
FRONT
L
R
7
1
2
3
4
5
6
7
8
L
Advertisement
Table of Contents
