Table of Contents
Advertisement
Setup
Sets the beep sound every time a button is pressed.
BEEP 2nd
The beep is generated when a key is long pressed. (1 sec)
BEEP ALL
The beep is generated when any key is pressed.
DEMO ON / OFF
You can change the initial indication on the display to information name. (function name,
EQ name, etc...)
DEMO ON
When the unit is "Power on", press and hold MUTE/PWR (POWER/
control), Demo is displayed on screen.
DEMO OFF
Demo is not displayed on screen.
AUX In
It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this unit.
• Enable : When using a auxiliary equipment.
• Disable : When not using a auxiliary equipment.
AUX In Att. (Auxiliary In Attenuate)
You can adjust the volume level of each source to prevent radical changes in volume when
switching between sources.
Setting range : 0 dB / +6 dB
If the input level of the connected component is not high enough, increase the input level
properly. Without adjusting the line input level, you may be surprised at a loud sound when
you change the source from the external component to another source.
Contrast
You can adjust the display for easier viewing when lighting conditions change.
Dark : T -15.......+15 t : Light
Using the EQ (Equalizer)
Press EQ repeatedly. The indicator lights up in the following order.
Pop(P) t Classic(C) t Rock(R) t Jazz(J) t Vocal(V) t Salsa(SS) t Samba(SB) t
User1(U1) t User2(U2) t Off
• Pop
: Optimized for R&B, Soul and Country music.
• Classic
: Optimized for orchestral music.
• Rock
: Optimized for Hard Rock and Heavy Metal music.
• Jazz
: Sweet sound with soft feeling.
• Vocal
: Powerful realism with strong sound quality.
• Salsa
: Reproduces salsa music acoustics.
• Samba
: Reproduces samba music acoustics.
• User1
: Use the menu to set the sound level you want.
• User2
: Use the menu to set the sound level you want.
You can adjust each sound level to your preference. Once you select a USER mode and then
make an adjustment, it automatically stored for the currently selected USER mode.
Refer to the "Adjusting the sound level" on the page 11-12.
Adjusting the sound level
1 Press SEL (SEL on the remote control) repeatedly to select the mode you want to adjust
from volume, bass, middle, treble, balance and fader.
The indicator lights up in the following order.
VOLUME(VOL) t EQ - USER(BAS, MID, TRB) t BALANCE(BAL) t FADER(FAD)
11
on the remote
Advertisement
Table of Contents
