Download Print this page

MATE MTH-16 Usage Instructions page 3

Advertisement

CHECK MULTI TOOL ALIGNMENT (CONT.)
4.
Rotate the alignment tool to the active punching station (under the ram) and engage
the machine turret alignment pins to lock the active station in place.
CAUTION: Alignment MUST be checked at the punching position under the ram with
turret locked in place.
5.
Remove the piece of metal from between the tools and lower the Alignment Punch
down to the Die Carrier to check if the Alignment Punch downward vertical pins slide
into the die alignment holes.
6.
If the punch pins engage fully into the die holes, your station is properly aligned.
a. If properly aligned, proceed to next step
b. If the pins do not fully engage, you should align the station. Stop here and proceed
to the section "Alignment Procedure" for adjusting station alignment.
7.
Before rotating the turret to the tool change position, lift the Alignment Punch while
placing a piece of metal between the Alignment Punch and the Die or Die Carrier.
CAUTION: It is very important that the Alignment Punch Pins are NOT engaged with the
Die or Die Carrier when rotating the turret. Damage to the Alignment Tool and/or turret
is possible.
Mate Precision Technologies • 1295 Lund Boulevard • Anoka, Minnesota 55303 USA • Phone +1.763.421.0230 • 800.328.4492 • Fax +1.763.421.0285 • 800.541.0285
The Mate Logo is a registered trademark of Mate Precision Technologies Inc.
© Mate Precison Technologies Inc.
MATE 2-PIN LINE UP TOOL
USAGE INSTRUCTIONS
Dimensions in Inches(millimeters)
mate.com
LIT01233 Rev B
Step 4
Step 5
Step 6
Step 7

Advertisement

loading