Download Print this page

MATE MTH-16 Usage Instructions page 2

Advertisement

CHECK MULTI TOOL ALIGNMENT
1.
Install the Alignment Die at the tool change position
a. Remove Existing Die or Die Carrier
b. Insert Alignment Die or Die Carrier in its place tightening bolt(s) securely
2.
With the station still rotated to the tool change position, place a piece of metal on
top of the alignment Die or Die Carrier to prevent any upper tools from engaging into
the Die or Die Carrier.
WARNING: It is very important that the Alignment Pins are NOT engaged with the
Die or Die Carrier holes when rotating the turret. Damage to the Alignment Tool and/
or turret is possible.
3.
Slide the Alignment Punch into the Upper Tool holder of the machine and down onto the
piece of metal on the Die or Die Carrier.
Mate Precision Technologies • 1295 Lund Boulevard • Anoka, Minnesota 55303 USA • Phone +1.763.421.0230 • 800.328.4492 • Fax +1.763.421.0285 • 800.541.0285
The Mate Logo is a registered trademark of Mate Precision Technologies Inc.
© Mate Precison Technologies Inc.
MATE 2-PIN LINE UP TOOL
USAGE INSTRUCTIONS
Step 1a
Step 1b
Dimensions in Inches(millimeters)
mate.com
LIT01233 Rev B
Step 2
Step 3

Advertisement

loading