Mounting And Dismounting Covers; Base Cover - Toshiba TH450A-CRB Instruction Manual

5.3

Mounting and Dismounting Covers

Packing is attached to each cover set surface of the clean type robot.
Strictly observe the following procedures to mount and dismount each cover.
• Before mounting and dismounting each cover, be sure to turn off the main
power ("POWER") switch.
• When opening each cover, make sure that water or contaminant will not
enter the robot. If the power is supplied while water or contaminant is left in
the robot, you may get an electric shock or the robot may be damaged,
which is very dangerous.
5.3.1

Base Cover

In all, two (2) base covers are provided; the cover concurrently used for connector
panel and the cover concurrently used for battery box.
The replacement procedures for the former cover (i.e., cover concurrently used for
connector panel) are the same as those for the standard robot.
The cover concurrently used for the battery box is secured to the base with nine (9)
hexagon flat head screws (M5 × 10) by inserting the packing. As the cover is
connected with the connectors inside, DO NOT pull out the cover by force.
!
Fig. 5.3 Cover concurrently used for battery box
CLEAN TYPE SPECIFICATIONS MANUAL
DANGER
– 34 –
Packing
Cover concurrently
used for battery box
STE 80872-0