RIOTEC DC9257L Programming Quick Manual

Programming Quick Guide
-DC9257L: Docking Scanner
Docking Scanner:
Gently tap the trigger area at the middle of scanner, to enable the
scanner(for reading barcode)
Up Side
Trigger
Area
The touch sensor area is around middle of the scanner as drawing shown.
Installation
They are Plug &Play USB (HID) devices. When plugged into your Android
OTG devices, it can be recognized as barcode scanner and begin to scan
the barcode. Before using scanner, make sure the smartphone or tablet
is fully charged. Open your APP, they can work as a keyboard input.
Reset Configuration to Default
(scan from 1 to 3)
1 3
2
0001160
Barcode Configuration Method:
(Flow chart for setup procedure :)
Start
Configuration
Lower Side
Keyboard Country (For USB HID only)
0006010
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ' \ < > ~
USA
Denmark
France
Italy
1103007
Turkey F
1103006
Keyboard Country (For USB HID only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ' \ < > ~
End
Configuration
Japan
Finland
UK
Norway
1103008
Turkey Q
1103226
1
Belgium
Germany
Austria
Sweden
1D Symbologies – 1
UPC-E
ENABLE
UPC-A
ENABLE
Code 128
ENABLE
GS1-128
UCC/EAN-128
ENABLE
0412020
Spain
Russia
Portugal
DISABLE
DISABLE
DISABLE
DISABLE
0412010