Table of Contents
Advertisement
installation
installation
location
When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated with an average room temperature of between 16°C and 43°C. Avoid
locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight
as it may increase the electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly. This unit is not designed for use in a garage or outdoor
installation. Do not drape the unit with any covering.
levelling the unit
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the doors and magnetic seal alignments
will not be covered properly.
installing the rubber support
In the case the loading on the door is heavier than
in the unit, opening of the door may cause the
refrigerator the risk of tipping forward. To prevent
tipping, insert the rubber support at the bottom of
the door.
1. Tilt the appliance backward and locate the
screw hole at the bottom left side of the door.
2. Insert the screw into the hole of the rubber
support.
3. Align the rubber support with the hole on
the bottom left side of the door, then tighten
securely with a screwdriver.
free space requirements
When installing the unit, ensure that 25 mm of
free space is left at both sides, 50 mm at the
rear of the unit and 25 mm at the top of the unit.
The door can be opened to the right or the left,
depending on which best suits the location.
Please ensure there is more than twice the width
and depth distance space of the unit to fully open
the door to a maximum angle of 160°.
scr ew
rubber support
Max. 160°
X mm
Y mm
7
Advertisement
Table of Contents
