Table of Contents
Advertisement
installation
location
When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated with an average room temperature of between lO'C and 43°C. Avoid
locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight
as it may increase the electricai consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly. This unit is not designed for use in a garage or outdoor
installation. Do not drape the unit with any covering.
levelling the unit
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the doors and magnetic seal alignments
will not be covered properly.
/ H
free space requirements
When installing the unit, ensure that 25 mm of
free space is left at both sides, 50 mm at the
rear of the unit and 25 mm at the top of the unit.
The door can be opened to the right or the left,
depending on which best suits the location.
Please ensure there is more than twice the width
and depth distance space of the unit to fully open
the door.
installing the door handles
1. Remove the screws from the doors.
2. Take the door handles and remove the handle screw caps
from the door handles, Align the door handles with the
screw holes on the doors and screw tightly. Replace the
handle screw caps on the door handles.
3. Insert the door handle screw hole covers into the screw
holes on the other side of the doors.
Hide quick links:
Advertisement
Table of Contents
