Table of Contents
Advertisement
installation
installation
location
When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated with an average room temperature of between 10°C and 43°C. Avoid
locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight
as it may increase the electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly. This unit is not designed for use in a garage or outdoor
installation. Do not drape the unit with any covering.
levelling the unit
Adjust the two levelling feet at the front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
free space requirements
When installing the unit, ensure that 25 mm of
free space is left at both sides, 50 mm at the
rear of the unit and 25 mm at the top of the
unit. Please ensure there is more than twice
the width and depth distance space of the unit
to fully open the doors to a maximum angle.
installing the water filter
•
Choose a wall area with distance that is near the water tap and the unit.
•
Do not install the water filter behind the unit, but should install it in an area that is convenient
for it to be replaced.
•
To operate properly, connect the unit to the water mains with water pressure of 207~689
Mpa.
Do not install the water filter on the unit body.
Once the area to install the water filter is determined, follow the steps below:
1. Screw the filter holders on the wall. Make sure the distance between the
filter holders is suitable to hold the water filter in place. The water filter
should be positioned vertically.
2. Measure the distance between the water filter and the water tap, and also the distance
between the water filter and the fridge. Cut the water hose into 2 water hoses accordingly to
the measured distances.
Y mm
X mm
Y mm
X mm
9
Advertisement
Table of Contents
