Advertisement
ASSEMBLY
Recharge only with the charger
WARNING
manual supplied with your charger and battery.
Using with Heated Gear
To insert the battery, slide the pack into the body
of the battery holder. Make sure it latches securely
into place.
Insert the power cable (from inside the battery holder
pocket) into the power cable port on the battery holder.
Place the battery holder into the pocket and fasten
closed.
To remove the battery, push in the release buttons
and pull the battery pack away from the holder.
NOTE: USB A Port (for device charging) and DC out
port (for powering heated gear) is shut down when
the Micro-USB port is being used.
Using the USB A Port
The USB A port can be used to charge a mobile
phone, MP3 player, or other personal device that
uses less than 5V, 2.1A of DC electrical current.
The cord can be run from the battery controller
pocket, through the grommet and channel on the
interior of the vest, and through another grommet
into a side pocket. It is not recommend to use the
pocket warmer when an electronic device is
charging in a pocket.
To turn on the USB, press the USB power button.
The USB A port will remain on for two hours before
turning off automatically.
NOTE: USB A Port (for device charging) and DC out
port (for powering heated gear) is shut down when
the Micro-USB port is being used.
Fuel Gauge
Press the USB power button to display the battery
pack's remaining power.
-
5
Advertisement
