Table of Contents
Advertisement
Other settings
Message indicator
The message indicator is located on top of the
handset and informs you of the following
status with its flashing.
Indicator
Status
Flashing
– Incoming call is now being
rapidly
received. (page 14)
– An alarm sounds.
(page 27)
Flashing
– There are missed calls.
*1
(page 32)
slowly
*1
To activate, setting of message indicator
must be "On". (page 13)
Setting the message indicator
The message indicator for the following
feature must be "On".
– "Missed Call" (Default: Off)
1
M
N#278
2
M N
R " " is displayed next to the selected
feature.
R To cancel a selected feature, press
M N again. " " disappears.
3
MOKN a M
N
Note:
R If the message indicator flashes when the
handset is not placed on the base unit,
battery consumption is faster than usual.
Eco mode setting
You can select the desired eco mode setting
by pressing MR/ECON.
The following settings are available for eco
mode.
– "Eco": Reduces the base unit transmission
power by up to 90 % in standby mode.
When this setting is selected,
displayed on the handset display instead of
.
TGE610HK(en_en)_0817_ver022.pdf 13
– "Eco Off" (default setting): Turns off eco
mode.
When this setting is selected,
displayed in the handset display.
Note:
R When eco mode is active, the range of the
base unit is reduced in standby mode.
R If you set repeater mode to "On"
(page 31):
– Eco mode is disabled.
– "Eco Mode" is not displayed in the
display menu (page 24).
Dialling mode
If you cannot make calls, change this setting
according to your telephone line service. The
default setting is "Tone".
"Tone": For tone dial service.
"Pulse": For rotary/pulse dial service.
1
M
N#120
2
MbN: Select the desired setting. a MOKN
a M
N
Low battery alert
This feature allows the unit to beep when the
battery needs charging.
When this feature is turned on, the unit notifies
you as follows.
n When the handset is in standby mode:
– If the battery needs charging, the unit
beeps at the selected interval up to 3
times.
Note for handset:
R At the end of each call, the unit displays a
large icon for a few moments to indicate the
battery level.
Setting low battery alert
To turn this feature on, select the desired alert
interval, or select "Off" to turn this feature off.
The default setting is "Every Hour".
1
M
N#176
is
2
MbN: Select the desired setting. a MOKN
a M
N
Getting Started
is not
13
2018/08/23 12:37:45
Advertisement
Table of Contents
