Upgrading Your Machine's Software Using Usb Flash Drive - Brother NV870SE Operation Manual

Upgrading your machine's software using USB flash drive

You can use USB flash drive to upgrade software for your
machine.
When an upgrade program is available on our website at
" http://support.brother.com/ ", please download the file(s)
following the instructions on the website and steps listed
below.
Note
• When using USB flash drive to upgrade the
software, check that no data other than the
upgrade file is saved on the USB flash drive
being used before starting to upgrade.
• Upgrade file can be recalled from a USB flash
drive of any size.
• Allow several seconds for machine to recognize
flash drive connection.
Memo
• When the machine's software is upgraded, saved
embroidery patterns will not be erased.
a Turn on the machine while pressing and holding
(Presser foot lifter button).
→ The following screen appears.
b Insert the USB flash drive into the USB port on the
machine. The media device should only contain the
upgrade file.
1 USB port
2 USB flash drive
Upgrading your machine's software using USB flash drive
Note
• When using USB flash drive equipped with an
access indicator, the access indicator will begin
flashing after the media is inserted into your
machine, and may take about 5 to 6 seconds
before the media is recognized. (The length of
time varies depending on the USB flash drive.)
c Press .
→ The following screen appears.
Note
• If an error occurred, a text error message will
appear. At this time, turn the machine off, and then
start the procedure again from step
When the following screen appears, upgrading is
d
completed.
e Remove the USB flash drive after turning off the
machine, and then turn on the machine again.
A
a
.
Appendix A-13