Mitsubishi Electric MSZ-LN18VGW - E1 Service Manual page 40

OPERATING PROCEDURE
How to install the front panel (Photos 1, 2, 3)
(1) Attach the right and left arm holders (Photo 2).
(2) Install the front panel to the indoor unit.
(3) Attach the safety string to the center of the panel
(F).
(4) Push the locations indicated by the arrows firmly
to close the front panel (Figure 2).
Removing the panel (U) (Photo 1)
(1) Remove the front panel.
(2) Insert a flat tool such as a ruler into the groove of the
stopper of outer vane (R) (horizontal). Slide the tool
and remove the outer vanes (R) (horizontal). Remove
the outer vane (L) (horizontal) in the same manner.
(3) Remove the 2 screw caps on the right and left sides
of the panel (U), and remove the 2 screws.
(4) Disengage the catch on the center of the panel (U),
and pull it toward you to remove.
How to install the panel (U) (Photo 1)
(1) Press the center of the panel (U) from the front to
snap into place.
(2) Install the 2 screws in the right and left sides of the
panel (U), and cover them with 2 screw caps.
Removing the panel (R) (Photos 1, 2, 3)
(1) Remove the front panel and the outer vanes (R) (L)
(horizontal).
(2) Remove the panel (U).
(3) Remove the 2 screws of the panel (R), and pull the
top of the panel (R) toward you to remove.
How to install the panel (R) (Photos 1, 2, 3)
(1) Install the panel (R) from the bottom to the top.
(2) Install the 2 screws in the panel (R).
Removing the panel (L) (Photos 1, 2, 3)
(1) Remove the front panel and the outer vanes (R) (L)
(horizontal).
(2) Remove the panel (U).
(3) Remove the screw of the panel (L), and pull the top of
the panel (L) toward you to remove.
How to install the panel (L) (Photos 1, 2, 3)
(1) Install the panel (L) from the bottom to the top.
(2) Install the screw in the panel (L).
Removing the panel (F) (Photo 3)
(1) Remove the front panel and the outer vanes (R) (L)
(horizontal).
(2) Remove the panels (U) (R) (L).
(3) Remove the Wi-Fi interface on the right side of the
panel (F). Pull out its cable, and remove the cable tie
(refer to 2).
(4) Remove the panel (F) from the bottom to the top.
How to install the panel (F)
(1) Install the panel (F) from the top to the bottom.
(2) Install the Wi-Fi interface.
(3) Install the panels (U) (R) (L).
(4) Install the outer vanes (R) (L) (horizontal) and the
front panel.
OBH766B
PHOTOS/FIGURES
Figure 2
Click
Photo 3
Screw of the
panel (L)
Panel (L)
40
Click
Panel (F)
Screws of the
panel (R)
Panel (R)