Installing A Protective Sealing On The Connector - Siensor D100 Series Passport Manual

Fig. 5.6 Installing a protective seal on the liquid level sensor
3. Connect the wire ends and fasten them by the seal.
5.3.2 Installing a Protective Sealing on the
Connector
1. Pass a sealing wire through the holes in the retainer
screw as shown in the figure (see Fig. 5.7).
Fig. 5.7 Installing a protective seal on the connector
2. Connect the wire ends, strain the wire and fasten
the seal.
When sealing, do not allow the wire to slack
between the holes on the connector!
17
1