Mounting Guidelines - Siensor D100 Series Passport Manual

5. MOUNTING GUIDELINES

Mounting procedure:
1. Select a place to install the LLS.
2. Prepare the fuel tank for installation.
3. Cut the LLS adjusting it to the depth of the fuel
tank.
4. Configure the LLS using the Siensor Monitor
application.
5. Mount the LLS.
6. Prepare and run a cable to connect the LLS to an
external device.
7. Connect the LLS.
8. Install the fuse.
9. Calibrate the fuel tank.
10. Sealing:
10.1. Installing a protective seal on the liquid level
sensor;
10.2. Installing a protective seal on the connector.
To provide optimum mounting of the LLS and better
tightness with the tank, it is recommended to mount
the LLS using five holes in the plate center (see Fig. 5.1).
12