Figure 5.5 illustrates the sample diagram of
connection the LLS to an external device using pins 4
and 8 to control connection integrity with the sensor,
where R is an external or internal pull-up.
External
device
Fig. 5.5 The sample diagram of connection one LLS to an
5.3 SEALING
5.3.1 Installing a protective seal on the liquid level
sensor
1. Fasten the retainer screw (see 1 in Fig. 5.6).
2. Pass the sealing wire through the holes in the
retainer screw and the sensor housing as shown in
the figure (see Fig. 5.6).
Circuit
On-board
power system
external device using pins 4 and 8
Siensor D107
Circuit
Contact 4
Contact 8
GND
PWR
16
LLS
Con
4
8
5
1