Supervisor Password; System Management Password - Lenovo ThinkPad X13 Gen 1 Hardware Maintenance Manual

Note: There are two modes for the hard disk password: User only and Master + User. The Master + User
mode requires two hard disk passwords; the system administrator enters both in the same operation. The
system administrator then provides the user hard disk password to the system user.
Attention: If the user hard disk password has been forgotten, check whether a master hard disk password
has been set. If a master hard disk password has been set, it can be used to access the solid-state drive. If
no master hard disk password is available, neither Lenovo nor Lenovo authorized service technicians provide
any services to reset either the user hard disk password or the master hard disk password, or to recover data
from the solid-state drive. The solid-state drive can be replaced for a scheduled fee.
For instructions on how to remove the hard disk password, see "How to remove the hard disk password" on
page 33.

Supervisor password

The supervisor password protects the system information stored in UEFI BIOS. It provides the following
security features:
• If only a supervisor password is set, a password prompt is displayed when you try to enter the UEFI BIOS
menu. Unauthorized users cannot change most of the system configuration options in the UEFI BIOS
menu without the password.
• The system administrator can use the supervisor password to access a computer even if the user of that
computer has set a power-on password. The supervisor password overrides the power-on password.
• The system administrator can set the same supervisor password on many ThinkPad notebook computers
to make administration easier.
Attention: If the supervisor password has been forgotten and cannot be made available to the service
technician, there is no service procedure to reset the password. The system board must be replaced for a
scheduled fee.

System management password

The system management password can also protect the system information stored in UEFI BIOS like a
supervisor password, but it has lower authority by default. The system management password can be set
through the UEFI BIOS menu or through Windows Management Instrumentation (WMI) with the Lenovo
client-management interface.
You can enable the system management password to have the same authority as the supervisor password
to control security related features. To customize the authority of the system management password through
the UEFI BIOS menu:
1. Enter the UEFI BIOS menu.
Note: When you are prompted, enter the correct supervisor password if a supervisor password has
been set, or enter the correct system management password if no supervisor password has been set.
Otherwise, you cannot change the configurations in the following steps.
2. Select Security ➙ Password ➙ System Management Password Access Control.
3. Follow the on-screen instructions.
If you have set both the supervisor password and the system management password, the supervisor
password overrides the system management password. If you have set both the system management
password and the power-on password, the system management password overrides the power-on
password.
32
T14s Gen 1 and X13 Gen 1 Hardware Maintenance Manual