Advertisement
4.2.2. HOW TO READ THE VALUES OF THE CYLINDRICAL TYPE CHIP
COMPONENTS.
The widest color band must be read first for value.
1. RESISTOR
There are two types (ERD10LLJ... and ERD10TLJ...) of chip parts.
A. ERD10LLJ: Refer to above type.
B. ERD10TLJ: The narrow color band must be read first for value.
If this part is included in the parts list, be sure that the
color band is read properly when servicing.
2. CAPACITOR
Because of the width of the color bands, the reading direction
cannot be specified. However, the color band can be read on either
side. Be sure to confirm the value using the schematic diagram.
CAUTION :
Once chip parts are removed, they must not be reused.
Always use a new part when installing a chip part.
5. DISASSEMBLY/ASSEMBLY PROCEDURES
5.1. CABINET SECTION
5.1.1. Disassembly Flowchart
Perform all disassembly procedures in the order described in the "Disassembly Flowchart"
shown below. When reassembling, use the reverse procedure.
CAUTION:
Disconnect AC plug before disassembly.
Fig. D1
19
Advertisement
