Connecting To A Power Supply - Hitachi MP-AW4001 User Manual

Connecting to a power supply

1.
Put the connector of the power cord into the
AC (AC inlet) of the projector.
2.
outlet. In a couple of seconds after the power
supply connection, the POWER/STATUS1
indicator will light up in steady orange.
Please remember that when the DIRECT POWER ON
function is activated, the connection of the power
supply makes the projector turn on. When the
AUTO POWER ON function is activated and the
projector is receiving an input signal, it is turned on by
connecting to the power supply.
WARNING
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Unplug the power cord for complete disconnection.
• Do not distribute the power supply to multiple devices. Doing so may overload
or other accidents.
• Do not press the main body of projector on the power cord.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
NOTICE
This product is also designed for IT power systems with a phase-
to-phase voltage of 220 to 240 V.
Fastening the cable
Use the supplied cable tie to fasten the cable.
Please use extra caution when connecting the power cord, as
Cable tie - large
AC
Power cord
9