Arrangement - Hitachi MP-AW4001 User Manual

Arrangement

Refer to tables T-1 and T-2 an
the screen size and projection distance.
The values shown in the table are calculated for a full size screen.
Screen size (diagonal)
a
projector, consult your dealer about your installation.
• The screen position may shift after installation if the projector is mounted on locations
is necessary, consult with your dealer or service personnel.
•
minutes after the light source is turned on) or when the ambient conditions change.
• Since the projector features an ultra short throw, be aware that it is required to select a
screen carefully to have better performance.
- A soft screen such as a pull-down screen may cause serious distortion of a projected
image. A hard screen such as a board screen is recommended for use with this projector.
- A high-gain screen such as a bead screen that has narrow viewing angle is not suitable
for this projector. A low-gain screen (around 1.0) such as a matte screen that has wide
viewing angle is recommended for use with this projector.
- A screen with a weave pattern may cause moire on the projected image, which is not a failure
of the projector. A screen that has less moire effects is recommended for use with this projector.
WARNING
Keep a space of 50 cm or more between the sides of the projector and other
objects such as walls. Do not place or attach anything that would block the
projection window or vent holes. Do not place the projector where the air from an air
conditioner or similar unit will blow on it directly.
and removing the projector with the mounting accessories to the service personnel.
CAUTION
Position the projector to prevent light from directly hitting the projector's remote sensor.
NOTE • Installation position, picture mode, altitude, and operating environment
may affect the brightness of the display.
6
F-1 and F-2 at the end of this manual to determine
Projection distance (±8%)
b1 , b2
18
, Screen height (±8%)
c1 c2