Arrangement - Hitachi CP-TW3506 User Manual

Hide thumbs Also See for CP-TW3506:
Table of Contents

Advertisement

Arrangement

Refer to tables T-1
screen size and projection distance.
The values shown in the table are calculated for a full size screen.
Screen size (diagonal)
a
be set up with the designated optional accessories (
consult your dealer about your installation.
  The screen position may shift after installation if the projector is mounted on locations
is necessary, consult with your dealer or service personnel.
 
minutes after the lamp is turned on) or when the ambient conditions change. Readjust
  Since the projector features an ultra short throw, be aware that it is required to select a
screen carefully to have better performance.
- A soft screen such as a pull-down screen may cause serious distortion of a projected
image. A hard screen such as a board screen is recommended for use with this projector.
- A high-gain screen such as a bead screen that has narrow viewing angle is not suitable
for this projector. A low-gain screen (around 1.0) such as a matte screen that has wide
viewing angle is recommended for use with this projector.
- A screen with a weave pattern may cause moiré on the projected image, which is not a failure
of the projector. A screen that has less moiré effects is recommended for use with this projector.
WARNING
such as walls. Do not place or attach anything that would block the projection
window, camera lens or vent holes. Do not place the projector where the air from an
air conditioner or similar unit will blow on it directly.
and removing the projector with the mounting accessories to the service personnel.
CAUTION
Position the projector to prevent light from directly hitting the projector's remote sensor.
If the projector is used at an altitude of about 1600 m or higher, set ALTITUDE of
If the projector is used with a wrong setting, it may cause damage to the projector
itself or the parts inside.
NOTE
The projector may make a rattling sound when tilted, moved or shaken,
this is not a failure or malfunction.
F-1 and F-2 at the end of this manual to determine the
Projection distance (±8%)
b1 , b2
22) and service may be required. Tabletop use must
,
Screen height (±8%)
c1
c2
22
5

Advertisement

Table of Contents
loading

Table of Contents