Makita DFT024F Instruction Manual page 9

LED indicator / Beeper
► Fig.6: 1. LED indicator
LED indicator / Beeper on the tool shows the following functions.
Function
Check of the LED indi-
cator, light and beeper
operation
Detection of switch
trigger operation when
installing battery
Auto-stop with fastening
completion
Alarm against insuffi-
cient fastening
Intermission between
the phases
Double-hitting detection
Alarm for low battery
capacity
Auto-stop with low
remaining battery
capacity
Anti-reset of controller
Overheat protection
Failure to detect heat
of motor
Motor failure detection
Maintenance alarm
Alarm for unavailable
data communication
(with the tool in connec-
tion with PC)
Status of the tool
When the battery Lights up first in green,
cartridge is installed, next red.
the tool checks for its (And then the light
LED indicator, light and comes on.)
beeper.
When the battery car- Blinks in red and green
tridge is installed with alternatively.
the switch trigger pulled,
the tool stops to avoid
unintentional start.
The tool setting has Lights up in green for
been achieved and the approximately one
tool has stopped. second.
The tool has not com- Lights up in red.
pleted the tool setting
because the switch
trigger has released
before reaching the
set values. Otherwise,
the settings of "Failure
Criteria for Phase" has
been achieved.
The tool is in the inter- Lights up or blinks in
mitting period configured green (depending on
by the setting of "Shift to settings)
the next Phase".
When the operator Lights up in red.
starts to re-fasten an
already-fastened screw,
the tool detect it and
stops.
The battery power Blinks in red slowly.
became low and it is
time to replace the
battery cartridge.
The battery power is Lights up in red.
almost used up and the
tool stopped.
The battery voltage Blinks in red and green
dropped abnormally for alternatively.
some reason, and the
tool stopped.
The motor or the control- Blinks in red quickly.
ler heated up abnormally
and the tool stopped.
The detection unit of Blinks in red quickly.
the motor fails to detect
the heat because the
cord has broken or other
reasons.
Motor failure has been Blinks in red and green
detected. At this time, alternatively.
tool does not work.
A maintenance time has Blinks in yellow.
come according to your
preset number of screws
driven.
Data cannot be Blinks in yellow.
exchanged between the
tool and PC in spite of
the connection.
Status of the LED indicator/beeper
LED indicator
A series of very short
beeps
A series of short beeps
A long beep
A long beep
A series of long beeps
A long beep
A series of short beeps
A series of short beeps
A series of short beeps
A series of short beeps
9 ENGLISH
Action to be taken
Beeper
Release the switch
trigger.
–
Retighten the screw.
–
Replace the battery with
fully charged one.
Replace the battery with
fully charged one.
Replace the battery with
fully charged one.
Remove the battery car-
tridge immediately and
cool the tool down.
Remove the battery
cartridge and cool the
tool down. If the indicator
does not stop, ask your
local Makita Service
Center for repair.
Ask your local Makita
Service Center for repair.
– Reset the alarm with the
application software.
– Restart the application
software and re-connect
the USB cable.
–
–
–
–