4
Figure 1
D
Cover
Screws
C
wall mount, single face only
Figure 3
B
Figure 5
DUAL UNIVERSAL AC SIGN
GREEN Ground
A
24 hours
Chassis GND
Unswitched Supply
BLACK 105 to 360VAC
WHITE Neutral
4
GREEN Ground
24 hours
Unswitched Supply
BLACK 120VAC
RED 347VAC or ORANGE 200-277VAC
WHITE Neutral
1.
BeLuce Canada Inc. strongly recommends compliance with all Code requirements.
2.
The lamps listed herein when used according to the instructions with this unit are in accordance with the requirements of CSA Standard
C22.2, No. 141 – Unit Equipment for Emergency Lighting.
3.
Clean faceplates/lenses on a regular basis.
CAUTION:
Always turn off AC power before servicing. The servicing of any parts, should be performed by qualified
EXIT SIGN DOES NOT COME ON AT ALL
1.
Check AC supply and all AC connections - be sure exit has 24 hour AC supply (unswitched).
2.
Check supply voltage and AC connections. The AC supply must be at least 80% of nominal (96V on a 120V line)
for equipment to function normally. At lower voltages the LEDs may begin to glow dimly until the source voltage
drops below the full "turn-on/off" point.
NOTE: This condition may also be caused by incorrectly connecting a voltage supply line
to the transformer lead.
3.
If AC supply is OK; replace LED circuit board assembly.wrong voltage transformer lead.
BeLuce Canada Inc., 3900 14th Avenue, Markham, ON L3R 4R3 P: (905) 948-9500 F: (905) 948-8673
926000287
3
Mounting Feet
(four in total)
Self-powered signs:
connect battery
From Generator OR
Emergency Supply
LED Board
BROWN 105 to 360VAC
BLUE Neutral
3
AC ONLY SIGN
Chassis GND
LED Board
NOTE: Cap unused AC Wire!
service personnel. The use of replacement parts not furnished by BeLuce Canada Inc. may cause
equipment failure and will void the warranty.
TROUBLESHOOTING
SAVE THESE INSTRUCTIONS
2
Figure 2
B
Magnetic
Test
Figure 4
A
24 hours
Unswitched Supply
RED 347VAC or ORANGE 200-277VAC
PART #
2
GREEN Ground
24 hours
Unswitched Supply
BLACK 120VAC
RED 347VAC or ORANGE 200-277VAC
WHITE Neutral
MAINTENANCE
unscrew and swing
open hinged cover
4
This document is the property of and contains information proprietary to Beghelli Canada, Inc. It is submitted in confidence and is to be used solely for the
purpose for which it was furnished and returned upon request. This document and such information is not to be reproduced, transmitted, disclosed, or used
SELF-POWERED SIGN
otherwise in whole or in part without prior authorization of Beghelli Canda, Inc. The recepient's acceptance of this document shall be considered an
agreement to the foregoing.
GREEN Ground
PART NAME
3900 14th AVE.
MATERIAL
Chassis GND
Markham Ontario, L3R 4R3
UNLESS OTHERWISE SPECIFIED
Tel. # 905 948-9500 Fax # 905 948 8673
LED Board
ALL DIMENSIONS = INCHES
email: sales@beghellicanada.com
FINISH
ANGLES + 1/2
Web: http://www.beghelli.com
BLACK 120VAC
TOLERANCES:
DRAWN BY
DATE
.X =
.020
L D
2/21/2012
.XX =
.010
.XXX =
.005
SIZE
SCALE
REF NO
.XXXX =
.003
WHITE Neutral
DO NOT SCALE
NOTE: Cap unused AC Wire!
AC & UNIVERSAL DC SIGN
Chassis GND
LED Board
NOTE: Cap unused AC Wire!
1
D
drill hole
for AC
supply
C
PART #
3
B
ROBUSTO RM DRAWING FOR
A
INSTRUCTION SHEET
Ni-Cd
Battery
DWG NO
REV
SHEET
1
Emergency Supply
FROM Battery Pack
YELLOW Positive 6 to 24VDC
PURPLE Negative
Need help?
Do you have a question about the ROBUSTO RM and is the answer not in the manual?