Q5X QT-5100 Series User Manual page 6

Regulatory Information
Antenna / Connector Type Manufacturer
¼" Wire Antenna
SSMA ¼" Whip Antenna
RF Exposure Compliance:
The QT-5100 module is granted with a modular approval for portable applications. The module is to be
used by Quantum5X in their final products without additional FCC/ISED certification if they meet the
certification conditions.
Module Integration into Host End Products:
The QT-5100 module transmitter has been designed by Quantum5X Systems Inc. to be used by Quantum5X
as a building block for their wireless audio transmitter products. The module, as designed, is a standalone unit
that is ready for integration into final form factor with the limitation for mobile use as specified in RF Exposure
compliance. For proper usage of the module, the module integrator must ensure that the input power and input
audio signal do not exceed the specified limits as outlined in the specification section. Failure to do so will result
in damage to the module. Final product(s) after integration with this module shall be tested to comply with all
applicable FCC requirements and Unintentional radiators (FCC section 15.107, 15.109 and ISED ICES-003) before
declaring compliance to Part 15 of the FCC Rules and ISED ICES-003.
The module integrator may not do the following. Failure to comply with these restrictions will result in violation of
the FCC certification.
1. Alter, modify or remove the module case.
2. Make changes to the Circuit Card Assembly of the module.
3. Remove, change or alter the integrated UHF antenna or the 802.15.4 antenna.
Labelling of the End Products:
The modular transmitter must be equipped with either a permanently affixed label.
The modular transmitter must be labelled with its own FCC identification number,
and if the FCC identification number is not visible when the module is installed
inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. This exterior
label can use wording such as the following: ''Contains Transmitter Module" or
''Contains ". Any similar wording that expresses the same meaning may be used.
Sample labels, that must be used for the module and the product, are shown on
the right.
Q5X
Sam Woo Electronics
Connector Type
MHF-4L
MHF-4L - SSMA
6
Max Gain
UHF 0 dBi, 2.45GHz 2 dBi
UHF 0 dBi, 2.45GHz 2 dBi