Element Cycling; Turn Product On/Off; Operating The Cooking Elements - GE Profile JP3530 Owner's Manual

Element Cycling

Surface elements will cycle on and off to maintain the
temperature you have selected. All radiant surface elements
have a temperature limiter that protects the glass cooktop
from getting too hot, this is normal. The temperature limiter
may cycle the elements off more frequently if:

Turn Product On/Off

■ P ush the knob down and turn in either direction to the
setting you want. When the control is in any position
other than Off, it may be rotated without pushing it
down. You may feel a slight bump when it is rotated
through the Lo or Hi positions. You may hear slight
clicking sounds during cooking, indicating the control
is keeping the power level you set.
■ A HOT SURFACE indicator light will glow when any
radiant element is turned on and will remain on until
the surface is cooled to approximately 150°F.
■ B e sure you turn the control knob to Off when you
finish cooking. It will snap into the Off position.

Operating The Cooking Elements

Dual Surface Element
■ T o use the small surface element, turn the control
knob to the Small Burner settings.
■ T o use the large surface element, turn the control
knob to the Large Burner settings.
Tri-Ring Surface Element
■ T o use the large surface element, push and turn the
center control knob clockwise to
desired setting. This will activate the entire heating area.
■ T o use the medium surface element, push and turn
the center control knob clockwise to
the desired setting. This will activate the medium-size
heating area.
■ T o use the smallest surface element, push and turn
the center control knob clockwise to , stopping at the
desired setting. This will activate the smallest, inside
heating area.
12
■ The pan boils dry.
■ The pan bottom is not flat.
■ The pan is off-center.
■ There is no pan on the element.
, stopping at the
, stopping at
49-2000975 Rev. 1