Panasonic NA-16VX1 Service Manual page 27

Description
4 Replacement of
the water level
detector
5 Replacement of
the feed valve
All manuals and user guides at all-guides.com
Figure
3.Remove the two lead wire holders and the one
After remove the upper board,
1.Push the one pawl to outward as shown in figure,
2.Remove the connector and sub hose A from the
3.Remove the water level detector.
After remove the upper board,
1.Remove the four screws mounting the detergent
2.Remove the two screws and the two pawls
3.loosen the nut from the feed valve unit by using
-27-
NA-16VX1/16VG1/14VA1
Procedure
connector to remove the 3D sensor.
and pull the water level detector upward.
water level detector.
case A.
mounting the pressure hose case.
the spanner.