Panasonic NA-16VX1 Service Manual page 11

4-8 Hose and Cable Lengths
100
4-9 Levelling the machine
Using a level facilitates the adjustment.
When adjusting the machine to make it level, ensure all four stands are supporting it:
A
To adjust the stands, use A side of the included spanner.
4-10 Water-supply hose
Points to remember:
Don't twist, squash, modify or cut the hose.
Optimum water pressure in the main pipe is 0.03 MPa - 1.0 Mpa.
If the pressure is set higher than this, you'll need to install a depressurising valve.
Water-flow from the tap should be more than 5 litres per minute.
Connecting the water-supply hose
Attach the hose to a tap, and tighten
1
the plastic joint by hand.
2
Open the tap slowly and check there
are no leaks around the joint.
Caution: the joint is subject to water pressure.
All manuals and user guides at all-guides.com
135
105
130
On each stand, loosen the lock nut by turning it clockwise using the
A end of the spanner supplied.
Adjust all four stands in this way.
Use a spirit level to ensure the machine is standing correctly.
Lock nut
Tighten each lock nut by turning it anti-clockwise (towards the
Stand
machine body), again using the A end of the spanner supplied.
Ensure all four lock nuts are tightened
securely. Check the stands are still
B
bolted to the machine - if they're unbolted,
the machine will move around.
Hose with water-
supply valve
-11-
NA-16VX1/16VG1/14VA1
m i . n 1 0 m
m i . n 1 0 m m
Plastic joint
S a t n d a d r h o s e
m