Table of Contents
Advertisement
If the temperature and level
of the water in the drum are
too high and/or the drum still
rotates you cannot open the
door.
1. Touch the Start/Pause button.
In the display the related door lock
indicator goes off.
2. Open the appliance door. If
necessary, add or remove the items.
3. Close the door and touch the Start/
Pause button.
The program or the delay start
continues.
4. The door can be opened when the
program is complete. You may also
set a spinning or draining program/
option and than press Start/Pause
button. If the spin and drain
programs are not available in the
program dial, they can be set via
App.
12.12 End of the program
When the program has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active).
In the display all washing phase
indicators become steady and the time
area shows .
The indicator of the Start/Pause button
goes off.
The door unlocks and the indicator
goes off.
1. Press the On/Off button to deactivate
the appliance.
After five minutes from the end of the
program, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last
selected program. Turn the
program dial to set a new
cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
12.13 Draining water out after
end of cycle
If you have chosen a program or an
option that does not empty out the water
of the last rinse, the program is
completed, but:
• The display shows the indicator , the
option indicator
door locked indicator
indicator of the running phase
flashes.
• The drum still turns at regular
intervals to prevent the creases in the
laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Spin button to
decrease the spin speed proposed
by the appliance.
2. Touch the Start/Pause button:
• If you have set
drains the water and spins.
• If you have set
only drains the water.
The option indicator
while the indicator
goes off.
3. When the program is completed and
the door locked indicator
off, you can open the door.
4. Press the On/Off button a few
seconds to deactivate the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
12.14 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
ENGLISH
39
or
and the
. The
, the appliance
, the appliance
or
goes off,
flashes and then
goes
Advertisement
Table of Contents
