Setup And Assembly; Operation - Jet JAT-102 Operations & Parts Manual

Setup and Assembly

Any missing parts or damage should be reported
immediately to your JET
damaged tool. Read this instruction manual
thoroughly for operation, maintenance and safety
instructions.
Box contents:
1 Impact wrench
1 Operation and parts manual
1 Warranty card

Operation

The impact wrench must be
properly lubricated before operation. See
"Lubrication" section.
Figure 1
1. Remove protective cap from air inlet (Figure
1). If an in-line oiler is not being used, add 4
or 5 drops of air tool oil (not included) into the
air inlet.
2. Blow out air line to remove any dirt or
moisture, then connect air supply hose to
tool. Set air pressure to 90 psi.
IMPORTANT: Connecting a quick-change
coupling directly
recommended, as vibration may cause the
connection to fail. Instead, add a leader hose
and install any quick-change couplings
farther down the line.
®
distributor. Do not use a
to the tool is
3. Push socket (not included) onto anvil until it
clicks into position.
4. Push direction pin to select forward or
reverse (F/R) rotation.
5. Push in and rotate regulator dial to preferred
speed setting. Regulator settings are for
reference only and do not indicate specific
power settings.
withstand rated torque of impact wrench.
To loosen nut or bolt:
1. Select reverse rotation.
2. Place socket over nut, hold grip firmly, and
place other hand over top of housing. Gently
squeeze trigger.
Important: If tool cannot loosen nut, DO
NOT raise air pressure above 90 psi. If tool's
air regulator is in low setting, raise setting
and retry. If tool's regulator is already at
maximum, do not continue attempts to
loosen nut with this impact wrench. Use
other methods or tools to loosen nut.
3. Release trigger to stop impact wrench.
To tighten nut or bolt:
1. Install nut as far as possible by hand.
2. Select forward rotation.
3. Place socket over nut, hold grip firmly, and
place other hand over top of housing. Gently
squeeze trigger.
Important: If tool stalls while tightening, DO
NOT raise air pressure above 90 psi. If tools'
air regulator is in low setting, raise setting
and retry. If nut will not tighten on
maximum
attempts to tighten nut with this impact
wrench. Use other methods or tools to
tighten nut.
4. Release trigger to stop impact wrench.
NOTE: Do not overtighten. Fasteners with critical
not
torque settings should be fully tightened with a
torque wrench.
Make sure nut or bolt can
setting, do not
JET
continue
7