sparkfun CC3000 Hook-Up Manual page 17

Make sure that the correct COM port and correct Arduino board are still
selected unded Tools. Click the "Upload" button.
Go to Tools → Serial Monitor and ensure that the baude rate is 115200
baud. If the FastConnect is successful, it should connect to the network
setup by the SmartConfig example and ping www.sparkfun.com.
If you would like to see how the connection profiles work using non-volatile
memory, unplug the Arduino's USB cable for a few seconds and then plug it
back in before running the FastConnect sketch again. You will see how
FastConnect can connect to a stored profile even if the Arduino and
CC3000 lose power!
Resources and Going Further
The CC3000 provides an easy-to-use WiFi client to any project that
contains a SPI bus and a few GPIO lines. The example library was written
for Arduino, but the CC3000 can be used with almost any microcontroller.
To read more about the CC3000, refer to the following sites:
• TI's CC3000 Main Page
• TI's CC3000 Wiki
Page 17 of 18