Xomax XM-2DTSBN6214 Installation Manual page 48

Topic: Common solutions
EN
An error message "CAM"
or "Back": An error message
"CAM", "Back" or the like is
seen on the black or blue back-
ground of the display. There is
no access to the menu.
The remote control is
without function.
XOMAX
The ISO cable was not connected correctly.
Probably the pin assignment of the ISO cable for the
camera is identic with the one on the ISO port for
the ("reverse" entfernt) lights. Please check the both
assignments and revise them if required.
Note:
Though the design of ISO port is standardized, it's
pin assigment is not and may vary. Thus in case
of mismatch of connections due to different pin
assignments a simple plug'n'play connection may lead
to grievous errors.
Solution 1:
Please ensure that the battery film is removed. By
delivery the battery is protected by a film which
should be removed before usage.
Solution 2:
The battery could be empty. Please replace it if
required.
Solution 3:
Please make sure that the infrared receiver (labelled
with IR) on the control panel is not blocked.
Note:
You can test the functionality of the remote control
as follows: please hold the IR transmitter towards
a camera (e.g. a cell phone camera) and press any
button on the remote control. If the remote control
is operative you can see the infrared signal on the
display of the used camera device.
48 X M - 2 D T S B N 6 2 1 4