Basic Operations; Power Button; Reset Button - QNAP TS-53DU Series User Manual

4. Basic Operations

This chapter describes basic NAS operations.

Power Button

Operation
Power on
Power off
Force power off

Reset Button

Operation
Basic system reset
Advanced system
reset
Press the button once.
Press and hold the button for 1.5
seconds.
Press and hold the button for 5
seconds.
User Action
Press and hold the
button for 3 seconds.
Press and hold the
button for 15 seconds.
User Action
The following settings are reset to default:
• System administrator password: MAC address of
adapter 1 without special characters. For example, if
the MAC address of adapter 1 is 11:22:33:44:55:66,
then the admin password will be 112233445566.
Tip
You can find the MAC address of adapter 1
using Qfinder Pro. A label attached to the
device also lists the address as MAC1.
• TCP/IP configuration:
• Obtain IP address settings automatically via
DHCP
• Disable jumbo frames
• If port trunking is enabled (multi-LAN models
only), the port trunking mode is reset to "Active
Backup (Failover)".
• System port: 8080 (system service port)
• Security level: Low (Allow all connections)
• LCD panel password: (blank)
• VLAN: Disabled
The default factory settings are restored.
• To retrieve old data after an advanced system reset,
recreate the previous folder structure on the NAS.
TS-x53DU User Guide
Result
The NAS powers on.
The NAS powers off.
The NAS shuts down.
Important
Use this method only
when the NAS is
unresponsive.
Result
Basic Operations 44