Table of Contents
Advertisement
SA-HT540E / SA-HT540EB / SA-HT540EG
9 Self-Diagnosis and special mode setting
9.1.
Service Mode Summary Table
The service modes can be activated by pressing various button combination on the player and remote control unit.
Below is the summary of major checking:
Player buttons
Remote control unit buttons
STOP
9.2.
Service Mode Table 1
By pressing various button combinations on the player and remote control unit can activate the various service modes for checking.
Special Note:
Due to the limitations of the no. characters that can be shown on FL Display, the "FL Display" button on the remote control uni
is used to show the following page. (Display 1/Display 2).
0
Error code display
5
Jitter checking
6
Region display and mode
7
Micro-processor firmware version check
FUNCTIONS
DVD laser drive current check
3
CD laser drive current check
PAUSE
Writing of laser drive current value after replacement of optical
pickup (Do use this function only when optical pickup is
replaced.)
Initialization of the player (factory setting is restored.)
Used after replacement of micro-computer, FLASH ROM IC,
EEPROM and HDMI module.
ENTER
DVD module reset
Application
16
Note
(Refer to the section,
"9.3 DVD Self Diagnostic
Function-Error Code").
(Refer to the section "9.2
Service Mode Table 1 for
more information").
(Refer to the section "9.2
Service Mode Table 1 for
more information").
(Refer to the item "9.2.1.
Optical Pick-up Self-
Diagnosis").
(Refer to the section "9.2
Service Mode Table 1 for
more information")
(Refer to the section "9.2
Service Mode Table 1 for
more information")
Advertisement
Table of Contents
