Ultrasonic working principle: The ultrasonic cleaner uses transducers to generate sound waves; frequency is 28/40KHz. When the sound waves travel through the liquid, millions of tiny bubbles form and burst continuously. This process is called a “cavitation” effect. The bursting bubbles scrub everywhere the liquid can penetrate.
Connect the drain pipe with factory drainage system. Add water and Detergent. Set temperature based on requirement and turn on the heater switch. Adjust ultrasonic power to Min., then start ultrasonic and adjust ultrasonic power to requirement after normal vibration.
Page 4
Digital Pro Ultra Control Panel ON LIGHTS TIMER DISPLAY + TIME - TEMP - TIME + TEMP TIMER ON/OFF HEAT ON/OFF ULTRASONIC POWER WWW.ULTRASONICLLC.COM...
Connect fitted cable or replace a new No ultrasonic contact our service department D、 Transducer short circuit E、 Other reasons Connect ultrasonic button and adjust A、 Not strong ultrasonic cleaning Adjust liquid into the best surface B、 Too high too low liquid surface...
Warranty card Ultrasonic LLC Cleaner Model U2100 U3000 Out-of-factory 2020.12.18 Machine no. Working volt AC 120V 60HZ Max power 1200W(U2100) 1500W(U3000) Date Purchased ___/___/______ Maintenance record Maintenance Service Date...
Page 7
Looking for the best clean out of your machine? Look no farther than Ultra 1, 2, or 3!!! Heavy-duty immersion and carbon cleaner ultrasonic cleaning solution provides aggressive cleaning for the heaviest soils found in a wide range of industries.