Hdbt Receiver - Labgear HDBT HD2-MX8X8-70K User Manual

HDBT Receiver

Œ
—
1. POWER: LED indicates receiver is powered.
2. DC 24V: Alternative power supply socket should not be required as receiver is powered by PoE from the matrix.
3. HDBaseT IN: Standard HDBaseT signal input port. Connect HDBaseT transmitter with a UTP cable.
4. HDMI OUT: HDMI output port. This slot is where you connect the HDTV or monitor with HDMI cable.
5. IR IN: Channel 1 IR Receiver. Connect with Wideband IR Rx.
6. IR OUT: Channel 2 IR Transmitter. Connect with Wideband IR Tx.
7. RS232: Phoenix jack provide Serial port control signal from receiver or to receiver.
8. Connection Signal Indicator LED:
On (continuously): Transmitter and Receiver have a stable/good connection.
Flashing: Transmitter and Receiver have a poor connection.
Off: Transmitter and Receiver are not connected.
9. Data Signal Indicator LED
On: HDMI signal data and HDCP data is being received.
Flashing: The HDMI signal data only is being received.
Off: No HDMI signal data is being received.
˜
“
™
”
š › œ
7