Table of Contents
Advertisement
Back Panel
1. GND: Connect to Earth the Housing.
2. IR Matrix, IR EXT: if the panel sensor is obstructed or the unit is installed in a closed area out of infrared line of
sight, one of the IR RX receivers supplied can be inserted into the IR EXT port at the rear to extend the IR sensor
range and enable local control of the matrix. IR IN/OUT: Super IR control system interface. For further details,
please refer to the Super IR system control introduction.
3. PC CONTROL, TCP/IP: This port is the link for TCP/IP control, connect to an active Ethernet link with an RJ45
terminated cable. RS232: Connect to a PC or control system with D-Sub 9-pin cable for the transmission of
RS-232 commands.
4. AUDIO OUTPUT: The coaxial and analog audio output connects to the audio amplifier. The TX and RX for RS232
communication with the HDBT Receiver TX and RX.
5. HDMI INPUT: Connects to the HDMI input source devices such as a DVD player or a Set-top Box via HDMI cable.
6. VIDEO OUTPUT: HDMI OUTPUTs are used to connect HD displays within 20m. HDBT OUTPUTs connect to
the HDBT Receivers.
7. AC POWER INPUT: Connects to a mains socket using the AC power cord supplied.
Remote Control Functions
1. Power On /Standby
2. Input port selection. Press to select source device 1-8.
Press forward/back button to cycle through inputs 1-8.
3. Output port selection. Press to select output A-H or ALL.
5
Advertisement
Table of Contents
