Table of Contents
Advertisement
Faults and what to do about them
en
Filter in the water supply is
blocked
For this, first reduce the water pressure
in the supply hose:
Turn off the water tap.
1.
Select any programme (except
2.
Rinse O // 0 Spin/Drain [ ).
Press Start/Reload A . Allow the
3.
programme to run for approximately
40 seconds.
Set the programme selector to off
4.
position. Disconnect the mains plug.
Clean the filter on the water tap:
5.
Remove the hose from the water tap.
Clean the filter with a small brush.
For standard and Aqua-Secure
6.
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance,
Remove the filter using pliers and
clean the filter.
Connect the hose and check for
7.
leaks.
26
3
Faults and what to do
about them
Emergency release
F a u l t s a n d w h a t t o d o a b o u t t h e m
e.g. in the event of a power outage
The programme will continue
Note:
running when the power supply has
been restored.
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning. Wait until the drum has stopped
turning.
Caution!
Water damage
Any escaping water may cause water
damage. Do not open the washing
machine door if water can be seen
through the glass.
if the laundry has to be removed, the
washing machine door can be opened
as follows:
Switch off the appliance. Disconnect
1.
the mains plug.
Drain the water. ~ Page 25
2.
Pull the emergency release
3.
downwards with a tool and release.
The washing machine door can now
be opened.
Advertisement
Table of Contents
