Setting The Signal - Bosch WAK20168IN Instruction Manual And Installation Instructions

M

Setting the signal

S e t t i n g t h e s i g n a l
1. Activate the setting mode for the signal volume
Set to Ú.
2. Set the volume for the button signals (depending on the model)
Press the button repeatedly until the
desired volume is reached.
3. Set the volume for the information signals
Turn the dial one position to the right. Press the button repeat-
Press and hold the 0 button and turn one
position to the right.
Go to point
3 or
edly until the desired vol-
ume is reached.
Set to Ú to exit the setting mode for the signal volume.
Set to Ú to exit the setting mode for
the signal volume.
Setting the signal
Press and hold the button for
approx. five seconds until the
display elements light up. Set-
ting mode is activated.
en
23