Related Manuals for Bosch WAK20160IN
Summary of Contents for Bosch WAK20160IN
- Page 1 Washing machine WAK20160IN WAK24168IN en Instruction Manual and Installation Instructions...
- Page 2 Your new washing machine Display rules : Warning! You have chosen a Bosch washing machine. This combination of symbol and signal word indicates a possibly dangerous Please take a few minutes to read and situation. Not heeding the warning can become familiar with the advantages of cause death or injuries.
-
Page 3: Table Of Contents
Contents e n I n s t r u c t i o n M a n u a l a n d I n s t a l l a t i o n I n s t r u c t i o n s Intended use. -
Page 4: Intended Use
Intended use After-sales service ..31 Intended use Consumption rates ..32 For private domestic use only. ■ I n t e n d e d u s e The washing machine is suitable for Consumption values table . -
Page 5: Safety Instructions
Safety instructions If you lean on the washing Safety instructions ■ machine door when it is open, the washing machine Electrical safety may tip over and cause S a f e t y i n s t r u c t i o n s injuries. - Page 6 Safety instructions Warning Warning Danger of death! Eye/skin irritation! Children may lock themselves Detergents and care products in appliances, putting their lives may cause irritation if they at risk. come into contact with the eyes For appliances that have or skin. reached the end of their service Keep detergents and care life:...
-
Page 7: Environmental Protection
Saving energy and detergent authorized collection centers for ~ Page 12 disposal Energy-saving mode: The display ■ www.bosch-home.com/in/about- panel lighting goes out after a few bosch/responsibility.html minutes and Start/ See also: Reload A flashes. To activate the Contact No: 180042535287 (toll-free) lighting, press any button. -
Page 8: Main Points In Brief
Main points in brief Main points in brief M a i n p o i n t s i n b r i e f Connect the mains Turn on the water Sort the laundry. Open the door. plug. tap. -------- Select a programme Observe the... -
Page 9: Getting To Know The Appliance
Getting to know the appliance Getting to know the appliance Washing machine G e t t i n g t o k n o w t h e a p p l i a n c e Detergent drawer ~ Page 18 Controls/display elements Washing machine door with window handle... -
Page 10: Control Panel
Getting to know the appliance Control panel 8 Start/Reload A for starting, ( rpm 0, Ready in ð for changing interrupting (f.e. adding/removing the programme default settings laundry) and cancelling a Overview of all programme default programme settings ~ Page 16 @ Programme selector for selecting 0 SpeedPerfect G, Water plus Z a programme and for switching... -
Page 11: Laundry
Laundry You can find examples of levels of Laundry soiling on ~ Page 12 – Light: Do not prewash, select the P repare the laundry SpeedPerfect G setting if L a u n d r y necessary Caution! – Normal Damage to the appliance/fabrics –... -
Page 12: Detergent
Detergent Saving energy and detergent Detergent For light and normal soiling, you can C orrect selection of detergent save energy (lower washing D e t e r g e n t temperature) and detergent. The care label is crucial for selecting the correct detergent, temperature and Saving Soiling/note... -
Page 13: Overview Of Programmes
Overview of programmes Overview of programmes Programmes on the programme selector O v e r v i e w o f p r o g r a m m e s Programme/type of laundry/information Settings/Presettings of the pro- grammes are highlighted in bold Max. - Page 14 Overview of programmes Programme/type of laundry/information Settings/Presettings of the pro- grammes are highlighted in bold Max. 2 kg W l Wool Hand or machine-washable fabrics made of wool or that contain cold wool; – – – ... 800 rpm particularly gentle wash programme to prevent shrinkage of laundry, with longer programme breaks (fabrics rest in the detergent solu- tion) Notes...
-
Page 15: Starching
Overview of programmes Programme/type of laundry/information Settings/Presettings of the pro- grammes are highlighted in bold Max. 7 kg/4* kg Kidswear ³ Hard-wearing fabrics, heat-resistant fabrics made of cotton or linen 40 °C – – – ... 1200** rpm G, Z l Drum Clean Programme for cleaning and caring for the drum and the outer tub, 90 °C... -
Page 16: Programme Default Settings
Programme default settings The programme duration is Programme default automatically adjusted when the programme is running. Changes to the settings programme default settings or programme settings also change the The spin speed and programme programme duration. P r o g r a m m e d e f a u l t s e t t i n g s duration ("Ready in"... -
Page 17: Additional Programme
Additional programme settings Check that the drum is completely Additional programme drained. Drain if necessary. settings SpeedPerfect G A d d i t i o n a l p r o g r a m m e s e t t i n g s For washing in a shorter time with a washing result comparable to that of the standard programme. -
Page 18: Select Additional Programme
Operating the appliance Select additional programme Make sure that no items of laundry are trapped between the washing settings machine door and the rubber seal, and close the door. By selecting additional settings, you can better adapt the washing process to your items of laundry. -
Page 19: Start The Programme
Operating the appliance Filling Measuring aid* for liquid detergent *depending on the model Warning Eye/skin irritation! Position the measuring aid for Detergent and care products may spray measuring the correct amount of liquid out if the detergent drawer is opened detergent: while the machine is in operation. -
Page 20: Childproof Lock
Operating the appliance Childproof lock Both the YES and ¼ symbols lit up, ■ it is possible to add laundry. You can lock the washing machine to A flashing NO symbol, wait until YES ■ prevent the functions you have set from and ¼... -
Page 21: Programme End During Rinse Hold
Operating the appliance Programme end during rinse Removing laundry/switching hold off the appliance – – – 0 appears on the display panel Open the washing machine door and the Start/Reload A button and remove the laundry. indicator lamp flashes. Set the programme selector to off position. -
Page 22: Sensors
Sensors If the interruption causes the Sensors programme to be extended, the dot on the display flashes. A utomatic load sensing S e n s o r s The automatic load sensing function adapts the water consumption ideally to each programme depending on the type of fabric and the load. -
Page 23: Setting The Signal
Setting the signal Setting the signal S e t t i n g t h e s i g n a l 1. Activate the setting mode for the signal volume Set to Ú. Press and hold the 0 button and turn one Press and hold the button for position to the right. -
Page 24: Cleaning And Maintenance
Cleaning and maintenance Descaling Cleaning and Descaling should not be necessary if maintenance the detergent is measured out correctly. However, if it is required, follow the Warning manufacturer's instructions for the C l e a n i n g a n d m a i n t e n a n c e Danger of death! descaling agent. -
Page 25: Detergent Solution Pump Blocked
Cleaning and maintenance Detergent solution pump Carefully unscrew the pump cover, residual water may leak out. blocked Clean the interior, pump cover thread and pump housing. The Warning impeller in the detergent solution Risk of scalding! pump must be able to rotate. When you wash at high temperatures, Refit the pump cover and screw it on the water gets very hot. -
Page 26: Filter In The Water Supply Blocked
Cleaning and maintenance Clean the drainage hose and siphon For standard and Aqua-Secure connecting piece. models, clean the filter on the rear of the appliance: Remove the hose from the rear of the appliance, Remove the filter using pliers and clean the filter. -
Page 27: Faults And What To Do About Them
Faults and what to do about them. Caution! Faults and what to do Water damage about them. Any escaping water may cause water damage. Emergency release Do not open the washing machine door F a u l t s a n d w h a t t o d o a b o u t t h e m . if water can be seen through the glass. -
Page 28: Information On The Display Panel
Faults and what to do about them. Information on the display panel Display Cause/remedial action The washing machine door is unlocked. It is possible to add laundry. The temperature is too high. Wait until the temperature falls. ■ Water level too high. Not possible to add laundry. If necessary, close the wash- ■... -
Page 29: Faults And What To Do About Them
Faults and what to do about them. Faults and what to do about them. Faults Cause/remedial action Water is leaking out. Attach/replace the drainage hose correctly. ■ Tighten the screw connection of the supply hose. ■ No water supply. Start/Reload A not pressed? ■... - Page 30 Faults and what to do about them. Faults Cause/remedial action The symbol N flashes Too much detergent used? ■ in the display panel. Foam Mix one tablespoon of fabric softener with 1/2 litre water and pour into may escape from the compartment II (not for outdoor fabrics, sportswear fabrics or those made detergent drawer.
-
Page 31: After-Sales Service
After-sales service After-sales service If you cannot correct the fault yourself, A f t e r - s a l e s s e r v i c e (see section, Faults and what to do about them ~ Page 27), please contact our after-sales service. -
Page 32: Consumption Rates
Consumption rates Consumption rates Consumption values table C o n s u m p t i o n r a t e s Programme Load Energy consumption** Water** Programme duration** i Cottons cold 7 kg 0.21 kWh 68 l i Cottons 40 °C* 7 kg 0.75 kWh 69 l... -
Page 33: Safety Instructions
Positioning and connecting In addition, a hose clamp (24 - 40 mm diameter, available from specialist dealers) is required to connect the water drain hose to a siphon. Useful tools Spirit level for levelling ■ Wrench with: ■ – WAF 13 for loosening the transport locks, and –... -
Page 34: Installation Surface
Positioning and connecting Notes Notes In addition to the safety information Recess width of 60 cm required. ■ ■ listed here, the local water and Only install the washing machine ■ electricity supplier may have special underneath a continuous worktop requirements. -
Page 35: Hose And Cable Lengths
Positioning and connecting Unscrew and remove all four Right-hand connection ■ transport brace screws. Remove the sleeves. To do this, remove the mains cable from the holders. Fit the covers. Lock the covers firmly in place by applying pressure to the The following are available from Tip: snap-in hooks. -
Page 36: Water Outlet
Positioning and connecting Only tighten the screw connections Open the water tap carefully, ■ by hand. If the screw connections checking the leak tightness of the are tightened too much with a tool connection points. The screw (pliers), the thread may be connection is under mains water damaged. -
Page 37: Levelling
Positioning and connecting – The water drains away quickly Tighten the lock nut against the enough. housing. In doing so, hold the foot tight and do not adjust its height. The lock nuts on all four appliance feet must be screwed tightly against the housing. -
Page 38: Before Washing For The First Time
Positioning and connecting If an earth-leakage circuit breaker is Do not use the machine with an ■ ■ used, only a type which displays this extension box, extension cord, spike symbol is used: z. busters etc., as this may lead to Only this symbol guarantees improper grounding conditions. -
Page 39: Transportation
Positioning and connecting Transportation Installing the transport locks: Remove the covers and keep them e.g. when moving home in a safe place. Use a screwdriver if necessary. Preparatory work: Turn off the water tap. Reduce the water pressure in the supply hose. - Page 40 0344 892 8979 (Calls charged at local or mobile rate.) 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.) You can find the contact information for all countries in the attached after-sales service directory. Robert Bosch, Hausgeräte GmbH Carl-Wery-Straße 34 81739 München DEUTSCHLAND...