Updating The Server Configuration - IBM x3100 User Manual

Updating the server configuration

When you start the server for the first time after you add or remove a device, you
might receive a message that the configuration has changed. The
Configuration/Setup Utility program starts automatically so that you can save the
new configuration settings. See Chapter 3, "Configuring the server," on page 37 for
additional information.
Some devices have device drivers that you must install. See the documentation that
comes with each device for information about installing device drivers.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the RAID adapter documentation for information about
reconfiguring the disk arrays.
For information about configuring the integrated Gigabit Ethernet controller, see
"Configuring the Intel Gigabit Ethernet controller" on page 45.
35
Chapter 2. Installing optional devices